LEAD IN FINE AND FASHION JEWELLERY - THE LATEST FACTS: CURRENT LEGISLATION AND PROPOSED CHANGES (201

31/05/2020

  The presence of Lead in jewellery and accessories is an increasing matter for concern due to the harmful effects that Lead can have, particularly on children. Many suppliers are testing for Lead as part of their "due diligence" and Lead will certainly be included in the final REACH regulations. The current situation and the latest EU proposal are set out below. The Birmingham Assay Office welcomes the restriction of all toxic substances from situations where they could be detrimental to the health of the consumer. It supports the recommendation to limit lead by measurement of content as this will provide a more accurate, reliable and repeatable control. There are currently three different content levels recommended and these need to be resolved. Interested parties have until 28th May 2011 to make their comments at CURRENT SITUATION IN EUROPE:There is currently no specific EU legislation for lead in jewellery. One European Member State, Denmark, has national legislation in place for lead content. The restriction is laid down in Denmark Statutory Order No. 1082 of 2007.In the absence of such legislation, the EN71-3 Toy Safety standard is frequently used in the EU to assess toxic metals including lead in products, particularly those intended for children.  The test standard BS EN 71-3:1995 - Safety of toys (Part 3: Migration of certain elements) specifies the requirements and test methods for migration of various toxic elements (including lead) from toys. The Migration rate is defined as the amount of lead which is released from the article when it is submerged in artificial stomach acid. This is intended to simulate sucking and swallowing of jewellery.The maximum migration level accepted for Lead is 90 mg/Kg (equivalent to 0.009%, or 90ppm leachable lead). However, there have been recent moves to include specific levels for lead under the new REACH regulations and the UK supply chain for fine jewellery and fashion accessories should be aware of these developments.PROPOSED CHANGES IN EUROPEFRENCH PROPOSALRecently France produced a proposal (a so called Annex XV report) to restrict lead and its compounds in jewellery under the REACH Regulation. The initial draft proposed that; 'Jewellery which has a lead migration rate greater than 0.09 micrograms per square centimetre per hour (µg/cm²/hr)' would be prohibited from being produced and/or placed on the EU market. It was recommended that the proposed restriction would apply to all precious and fashion jewellery, whether it was intended for adults or children.The lead migration limit would be considered for each individual part of the jewellery and would be measured using the method from BS EN 71-3:1995 as referred to above.SUBSEQUENT CHANGES:The proposal was open for public consultation from 21.06.2010 until 21.12 2010. The response included much opposition to the suggested limit of 0.09µg/cm²/hr as it would involve calculating the surface area of an item of jewellery to give the migration rate - this can be a complicated and inaccurate process. Having considered the response to the consultation, and the opinion of the Risk Assessment Committee (RAC), the Committee for Socio Economic Analysis (SEAC) adopted a draft opinion and proposed restriction on Lead and its compounds in jewellery which proposes new restrictions as follows:The new legislation should be based on the content of lead in jewellery rather than the migration rate. "Lead .... And its compounds shall not be used in jewellery articles if the lead concentration is equal to or greater than 0.05% (500ppm) by weight of any part of the jewellery article"The products covered have been amended to be the same as those proposed for cadmium restrictions (which are also currently being reviewed);"Jewellery and imitation jewellery articles and hair accessories , including bracelets, necklaces and rings, piercing jewellery, wrist-watches and wrist wear, brooches and cufflinks".PLEASE NOTE:This covers both precious and fashion jewellery, intended for use by adults as well as children. Other articles (such as key rings, coins etc) that may also be mouthed and accidentally swallowed by children are not covered by this legislation. Non-metallic parts are included - lead is commonly found in plastics, varnishes, paints, enamels and lacquers.Precious metals - are not expected to contain lead and its compounds.  These metals have not been formally exempted from the restrictions but can be dealt with by Declarations of Conformity and periodic due diligence testing rather than by regular bulk testing. Precious metal jewellery will be restricted with regard to cadmium as soon as the Annex XVII entry enters into force (in 2012). No further additional 'due diligence' costs will be incurred as lead and cadmium can be tested simultaneously in solution by ICP-OES method.Crystals, precious and semi-precious stones - are not included in the restriction, by way of derogation, as the lea