Top of FormDriveway BlockerLatest news from Eikon Creations .Ltd 16/06/2009 SURFACE MOUNTED ROAD BLOCKER/ DRIVE BLOCKER AN ALTERNATIVE TO A GATE There is no need to get out of your car in the wet cold or dark to unlock gates or posts, keep your finger on the button of your key fob for six seconds to operate the Road Blocker/ Driveway Blocker from the safety and security of your own car. A surface mounted Road Blocker/Driveway Blocker is the ideal security product for keeping your vehicle on your drive and others off. (This product acts as a very strong deterrent against car theft). When not in use the Road Blocker/Driveway Blocker sits just 65mm of the surface of the drive which is suitable for the majority of production cars, when extended to its full height the Road Blocker/Driveway Blocker stands at 270mm on a foot print of 870mm sq its pyramid design creates a very strong but discreet barrier to keep your vehicles where they belong. Being surface mounted the Road Blocker/Driveway Blocker is very easily installed, simply fit by drilling 4 holes through the holes in the base plate and bolt down with supplied raw plugs and bolts. Thus eliminating the time consuming and costly disruption, often found when having automatic gates fitted, plus all the ground work that is involved bringing the 240 volt supply from your home .(Please note we can also supply a resin adhesive where ground anchorage is not suitable) You may find that the Road Blocker/Driveway Blocker would be a suitable alternative where open planning doesn't allow for gated systems. The Road Blocker/Driveway Blocker is a 24v battery operated system and should take approx 4 hours to fully charge, it has a built in safety cut out so you can't over charge the battery inside. The Road Blocker/Driveway Blocker should operate for approximately thirty days being used 12 times a day up and down per day without the need to charge or you can have it hard wired where the power cable exits from beneath the Drive Blocker then runs to the house via the most convenient route and plugged in to the nearest three pin 13amp socket. (The need for the constant finger on the button is a safety feature to ensure that it is only activated when in view and will stop immediately if released)this is to eliminate any possibility of injury that may occur to anyone getting to close to the product. There are blue flashing LEDs that can be seen when the Road Blocker/Driveway Blocker is being used to warn people in close proximity that the Road Driveway Blocker is in motion.If any one is standing on or in close proximity of the Road Driveway Blocker they should be moved away before activation is carried out.